Volkov Artem

Physical and Metallurgical Faculty
Speciality: Processing of metals with pressure

Theme of master's work:

Research of process of deformation of continuously cast ingots at a stage of incomplete crystallization

Scientific adviser:  professor Smirnov Evgeniy

Own publications

1. Research of process of deformation of continuously cast ingots at a stage of incomplete crystallization

   Author:: Volkov A.

   Description: The description: All - Ukraine scientifically-practical conference of students "Metallurgy of XXI century by young eyes ", 2010, DonNTU, Donetsk. In article was examined of the deformed bars rolling-slitting launching process in the mill 390 conditions .

Library on a theme of final work

1. Development and adoption of the manufacturing control system for a section mill 390 JSC MMP

   Authors: : SPO «DONIKS»

   Description: The article is devoted to the issues of development and adoption of the manufacturing control system. Application of the manufacturing control system in the mill 390 conditions gives following opportunities: to raise productivity and equipment loading, to use rationally production and labor resources; to lower waster and number of claims to quality due to the complex estimation of test results and analysis with recommendations of expert about technical process improvement; to raise suitable output ; to reduce the orders time performance due to rational planning of manufacture and reduction of non-productive idle times; to lower stocks of raw materials and a work in progress, industrial equipment at the expense of a statistical estimation of stocks volume really necessary for undisturbed operation; to raise management efficiency at the expense of a full transparency of manufacture, the complex data about expenses, productivity and production quality of each link.

   
   
2. Program complex for designing and the analysis of flat-and-edge rolling technology

   Authors:: Solod V. C. , Benetskij A.G., Mamaev A.N.

   Description: In the article we can observe a description of a complex program for designing and the analysis of flat-and-edge rolling technology, developed in SPО"Doniks". The main functions and software product possibility and also the sphere of its application are shown. Also there is a short description of settlement algorithms used in a complex program, and also ways of calculation and data presentation.

   
   
3. Application of universal mathematical model of a free contour forming for estimation of the form and the contact area in exhaust gauges.

   Authors:: Solod V. C. , Benetskij A.G., Kulagin R. J

   Description: In the article were represented results of universal mathematical model application, free from a strip surface contact for the description of the form and the areas of cross-section and the areas of metal contact with rollers in exhaust gauges.