Faculty:

Department:

Speciality:

Scientific adviser:

Theme of master's work:

Physical-and-metallurgycal

Physical material Sience

Applied material science

professor Vladimir Pashinsky

About Influence of the Temperature of Kh12-type Steels Quenching on Correlation of the Hardness and Amount of the Retained Austenite

OWN ARTICLE:

1. About influence of the temperature of Kh12-type steels quenching on correlation of the hardness and amount of the retained austenite (in Russian)

   Authors: associate professor S.Marchuk, M.Subbotina

   In the article the influence of the quenching temperature on correlation of the hardness and amount of the retained austenite of Kh12-type steels is studying. The possible explanation of the reasons of uncorreletion these parametres is stated.

   Source of information: The collection of works of the "10th International Scientific and Technical the Ural School-seminar of Young Metallographer Scientists", Ekaterinburg city, 2009

LIBRARY:

1. RESEARCH OF INFLUENCE OF THE STRUCTURAL CONDITION AND QUANTITY CARBID PHASE ON WEAR RESISTANCE OF CAST ALLOYS AFTER THERMAL PROCESSING IN SERVICE CONDITIONS OF DETAILS OF THE AMALGAMATOR

Authors: Antonyuk D., Popov S.M.

In the article standard dependence carbide phases, hardness and quantity of a residual austenite of steels Х12Ф1 and Х12 from training temperature is resulted, influence of structural components on properties, in particular on wear resistance of products from these steels is analysed.

Source of information: www.zntu.edu.ua

2. INFLUENCE OF ABRASIVE CIRCLES OF NORMAL AND HIGH POROSITY ON MICROHARDNESS OF STAMPS FROM STEEL Х12

   Authors: Soler A.I., Lgalov V.V.

   The surface microhardness research results are leaded at grinding of punches by abrasive wheels of various characteristics. The investigation revealed that microhardness depends of abrasive type and porosity.

   Source of information: www.science-bsea.narod.ru

3. INFLUENCE OF STRUCTURE AND STABILITY OF THE AUSTENITE ON ABRASIVE WEAR RESISTANCE

Authors: Malinov L.S., Solidor N.A., Rubec A.S.

Influence of temperature of heating under guenching on abrasive wear resistance is studied. It is shown that regulating structure and stability of an austenite in relation to deformation martensite transformation, it is possible to raise abrasive wear resistance.

Source of information: www.jet.com.ua

4. ISOTHERMAL MARTENSITE TRANSFORMATIONS

   Authors: Lobodyuk V.A., Estrin E.I.

   In article it is considered isothermal martensite transformation which is long develops in time at low temperatures. In the review the basic experimental data on кинетике IMT, existing representations about nature IMT and its communications with other kinetic variants of phase transformations are considered.

   Source of information: www.ufn.ru

5. MARTENSITE TRANSFORMATIONS

   Authors: Bilby B.A., Khristian I.V.

   In article extensive data about kinetics, the nature and factors martensite transformations are collected.

   Source of information: www.ufn.ru

6. STEELS FOR TOOLS OF COLD SHARPING

In this article standard dependence of hardness and quantity of a residual austenite of steel Kh12F1 on quenching temperature is resulted, influence of structural components on properties is analysed.

Source of information: www.prosibir.ru

7. STEEL FOR THE STAMPING AND FOR THE MEASURING TOOL

The review on the given subjects with instructions of features of properties and a chemical compound of steels is resulted.

Source of information: www.inmetal.ru

8. THERMAL PROCESSING OF THE TOOL

In article the general information on modes of thermal processing for every possible steels and products from them, and also concrete modes of quenching for steels of type Х12 contains.

Source of information: www.usfeu.ru